Installing Decals on Your Vehicle

BEFORE YOU BEGIN:

1) This product is specifically designed for set up on the outside of the vehicle.

2) Required Gadgets embrace an set up squeegee, masking tape, glass cleaner, dry paper towels, measuring tape or ruler.

3) Do not apply any vinyl graphics in direct sunlight. Make sure it is between 60 degrees and eighty degrees F. Park the vehicle within the garage in the shade. Let cool for 30 minutes if hot.

4) Do not store unapplied graphics in direct sunlight – damage may occur.

5) All filth, grease and wax should be removed from the automobile surface before the decal is applied. This contains wax from mechanical automobile washes, rain-x, compound, etc. Failure to take this step might outcome in the decal not sticking to the vehicle surface.

STEP 1 – UNPACK THE SHIPPING CONTAINER – Remove decals from packaging. Lay decals flat on a smooth table in an space that is no less than 60° F and under eighty° F.

STEP 2 – PREPARE THE SURFACE – The most important step throughout decal set up is making positive the set up space is clean and dry. Make sure there is NO WAX, RAIN-X, COMPOUND, lint, mud, or different residue on the surface. Remove all wax, compound residue, automotive wash protestants, etc with rubbing or denatured alcohol. After cleaning the surface, go over the surface with common glass cleaner.

STEP three – FIND DESIRED LOCATION OF THE STRIPES – Using a string or different line, place it over the vehicle from the front to the back in the desired location for the stripes. Be sure that the string is symmetrically centered on the vehicle. Mark this location with a pencil of different nonpermanent marking machine at the front and the rear of each body panel. This will function the location of the sting of the stripes.

STEP four – PLACE THE STRIPES – Measure the length of every body panel to which the stripe is to be applied. Lay the stripe part over the world of the vehicle, trimming the excess stripe off one end (leave at least an inch additional) Save all cut off items, as they can be utilized to cover bumpers and fins.

STEP 5 – SECURE THE STRIPES – Place a strip of masking tape at one end of the stripe, as this will hold the end of the stripe while installing. Working from that finish to the other, slowly peel back the release paper half of way down and spray the body surface with a fine mist of water resolution (not soapy answer). With a squeegee, apply the stripe to the body panel working from the center of the stripe outward. As you work additional down the stripe, slowly continue to remove the backing paper as needed. Slowly continue to apply the stripe with the squeegee, applying even pressure throughout the width of the stripe.

STEP 6 – REMOVE THE TRANSFER PAPER – Once your entire piece is utilized, remove the masking tape from the tip of the stripe. Subsequent remove the switch tape covering, careabsolutely pulling parallel to the surface of the vehicle (NOT UP BUT SIDEWAYS).

STEP 7 – FINISH INSTALLATION – Any small air pockets may be easily removed by first inserting a small gap in the bubble (small hole, not giant slice). Then moisten the squeegee edge with water and slide the squeegee along the surface of the stripe where the bubble is, working the air towards the hole.

CARE AND MAINTENANCE:

As soon as the decal is put in, to keep it looking new, merely wash it whenever you wash the vehicle. You can apply automobile wax, clearcoat, or RainEx over the decal as soon as it is applied. your new decal will provide you with years of nice looks. In case you are in cold climate be careful when utilizing an ice scraper on any surface the place decals are applied.

If you liked this report and you would like to obtain extra details about caravan stickers Australia kindly check out the website.